Move the gripper to the goal position, reaching over the wall

You are controlling a simulated robot. Read the task below, then solve it by running the robo command in your shell (start with robo info and robo observe). Keep going until the task is done, then call robo done once. Do not stop to ask questions; there is no human to answer.

How to control the robot

You are the robot's policy. You act only through the robo command in your shell. There is no other way to move the robot, and you cannot read or change the simulator, the scoring, or other files to succeed; the episode server judges the final physical state itself.

robo info                         # action space, available skills, step budget
robo observe                      # robot and object state as numbers
robo observe --image              # also saves a camera image and prints its path (open it to look)
robo act DX DY DZ GRIP [--repeat N]   # low-level action, applied N times (N <= 50)
robo move-to X Y Z [--grip G]     # skill: move the gripper toward a point (if enabled for this task)
robo grip G [--steps N]           # skill: hold position and set the gripper (+1 close, -1 open)
robo done "short summary"         # end the episode and ask for scoring
robo give-up "reason"             # end the episode without claiming success

• Positions are in metres in the world frame (x, y on the table plane, z up).
• The episode has a fixed step budget (see robo info); every simulated step counts, including skills.
• Unless the task says otherwise, success is judged about 10 steps after you call robo done, with the robot holding still, so the goal must still be true when the robot stops.
• Work in small steps and re-observe after each motion. Call robo done exactly once when finished.